6
PREPARING FOR USE
1. Carefully unpack the immersion blender and all parts. Remove any tape, labels or packaging materials.
2. Wash the blending shaft and whisk attachments with warm, soapy water. Rinse and dry thoroughly.
3. Wipe exterior surfaces of the immersion blender motor housing with a soft, moist cloth to remove dust particles collected during
packing and handling. NEVER IMMERSE THE MOTOR HOUSING, USB CORD OR CHARGER IN WATER OR ANY OTHER LIQUID.
4. Be sure all parts are properly assembled and in place before use.
HOW TO CHARGE
1. Open the charging port on the motor housing. Attach micro end of cable to the motor housing.
2. Attach the USB connector to the charger.
3. Plug the charger into the wall outlet.
4. Lights will flash while charging. The lights will stop flashing once the unit is fully charged. See Indicator Light section for details.
Note
: The unit is shipped with approximately 30% charge in the batteries. One or two lights will be illuminated during use. The unit
will operate properly without charging. It is recommended to fully charge before first use for best performance.
5. It will take approximately 5 hours to fully charge the unit.
6. Unit can be charged while stored in the storage base.
ATTACHING BLENDING SHAFT OR WHISK
To attach the blending shaft:
Hold the blending shaft with the blades down, and align the top end of the blending shaft with the corresponding end of the motor body.
Turn until it clicks into the lock position.
The whisk is attached in the same manner.
To detach blending shaft or whisk:
Ensure the speed button is released. Turn the blending shaft or whisk until it detaches from the motor body.