6
PREPARING FOR USE
PRIME AND CLEAN THE SYSTEM:
Before the first use, the Internal Boiler System of the Coffee Brewer must be primed and cleaned with water.
1.
Place the Water Tank on the Brewer and make sure it is properly seated on the Water Inlet.
2. Fill the Water Tank to the MAX level and replace Water Tank Lid.
3. Press
the Release Button on the front of the Brewer to release the Capsule Puncturing / Locking Mechanism and open the Slide-Out
Brew Chamber.
See Fig. 1 on Page 7 under USING THE BREWER.
4.
Insert the Brew Chamber Adapter (Ring) and the Shower Head Attachment into the Brew Chamber.
See Fig. 2 and Fig. 3 on Page
7 under USING THE BREWER.
5.
Align the Slide-Out Brew Chamber with the Brewer Housing and slide in place making sure it is completely closed.
See Fig. 8 on
Page 7 under USING THE BREWER.
6.
Lower the Capsule Puncturing / Locking Mechanism.
See Fig. 4 on Page 7 under USING THE BREWER.
NOTE: If the Slide-Out Brew Chamber is not properly aligned, the Capsule Puncturing / Locking Mechanism will not lower
and latch.
7. Place the Glass Carafe on the Drip Tray and beneath the Brew Spout.
NOTE: When using the Glass Carafe, the Drip Tray must always be in place.
8.
Plug the Coffee Brewer into an electrical outlet. Ideally, the Coffee Brewer should be operated on its own circuit, separate from other
appliances.
9.
Turn the Coffee Brewer ON by pressing the Power Button. All lights will be illuminated. To prime, push the 10 Cups Button. The
machine will prime the Internal Boiler and then start the cleaning cycle.
10.
During the priming cycle, all buttons will be illuminated and the 10 Cup Button will flash. After the priming cycle is complete, the
cleaning cycle will start automatically.
The Coffee Brewer will heat up, run a complete cycle and dispense hot water to clean the
system. When the cleaning cycle is complete, the 10 Cup Button will stop flashing and all five buttons will be illuminated.
CAUTION: DO NOT remove the Glass Carafe until the cleaning cycle is complete and the 10 Cups Button stops flashing and
all five buttons become illuminated.
CAUTION: DO NOT attempt to open the Capsule Puncturing / Locking Mechanism during the priming and cleaning cycles.
11.
When the cleaning cycle is complete, the Brewer is ready for use.
