Top Cover
Use of the top cover is optional, and its only
purpose is aesthetic. If you prefer a more traditional
pendant look, you may choose not to install the top
cap. However, if a more modern look is what you
are after then installing the top cover gives a
beautiful, organic shape to the pendant.
The decision to install the top cover should be made
before hanging the pendant, since installing the top
cover requires any speaker wire or hanging cables
to be threaded through the hole in the cover.
Painting
If you decide to paint your BeatDrop pendant, it is
best to temporarily hang it at a height that all
surfaces to be painted can be accessed. Depending
on the thickness of the paint, you may want to thin it
slightly. Care needs to be taken when painting to not
clog the holes of the grill with paint. The grill is not
removable. Always paint the grill at an angle, to
minimize the amount of paint that might pass
through the grill onto the speaker diaphragms.
Care and Maintenance
Your BeatDrop pendant was designed to give you
years of trouble-free enjoyment, with minimal care.
Hanging the Pendant
Specifications
Woofer: 8” molded polypropylene
Tweeter: 1” silk, soft dome
Impedance: 8 ohm or 70V / 100V
Power Handling: 5 – 125 Watts RMS (8 ohm)
70V Tap Settings: 4W, 8W, 15W, 30W, 60W
100V Tap Settings: 8W, 15W, 30W, 60W
Frequency Response: 42Hz to 20kHz
Sensitivity: 90 dB/W @ 1m
Dispersion Angle: 110 degrees
Grill Type: Steel
Diameter: 12.6” (321mm)
Height: 12.4” (316mm)
Height w/ Top Cap: 16.9” (430mm)
BD-8
Insert the cable into the
cable clamp as shown
Pass the cable over the
support, and back
through the cable clamp
1
2
Attach the carabiner to
the cable loop, and then
to the center mounting
hole of the pendant.
Add a second (safety) cable,
leaving it slightly loose
Adjust the height of the
pendant at the cable clamp
3
4
5
Safety
Thread the looped end of
the cable through the top
cap before attaching
the carabiner
The top cap presses into
place after all the cables
and wires are installed
It is the policy of TRUAUDIO to continuously incorporate improvements into our products. All specifications are subject to change without notice.
If you have any questions regarding this or any other TRUAUDIO products, please call 1-888-858-1555, Monday – Friday, 7:00 am – 6:00 pm MST.
TRUAUDIO Speaker Systems, Hurricane, Utah, 84737
Office: 435.986.1574 Fax: 435.251.9815
SoundVision Technologies dba TRUAUDIO
PRODUCT WARRANTY
All in-wall, in-ceiling, outdoor speakers, volume controls and freestanding loudspeakers have a limited lifetime warranty. This warranty includes lifetime parts
and repair labor on all components. Powered subwoofers and active electronics have a one (1) year limited warranty. This warranty includes one (1) year
parts and repair labor on all components. TRUAUDIO’s obligation under these warrantees is limited to repairing or replacing any component found defective
in material or workmanship under normal conditions of use. These warrantees shall not apply to products which have been abused, modified, disassembled,
or repaired by anyone other than TRUAUDIO or one of its appointed service centers. Products to be repaired under this warranty must be returned to the
factory or designated service center with all transportation and insurance charges pre-paid.
