Bed and Breakfast Instructions
the 2 tapped holes. Thread into the holes
your
½
-20 x
½
” set screws using your 3/32
allen wrench. Measure and mark the center
of the top perch rods. Insert the rod into the
hole doing the uppermost rod first. Tighten
the set screws See photos 3B and 3C.
Next place the black cap over the top of the
pole. See step 3C.
Step 4)
Next we will attach the 3 sections of
the pole together. Take your top pole sec-
tion and middle section. Align the middle
section so that the drilled and tapped hole on
the top section aligns with the set screw that
holds the splice into place. Insert the splice,
thread the
¼
”-20 x
¼
” (M) set screw into the
tapped hole. Align the set screw and tighten.
Next add the bottom section. Its the same
way. Align the set screw holes, insert the
screw and tighten.
Step 5)
Slip the hub onto the pole bottom
and slide it up the pole.
Step 6)
Rope Winder (K). The rope winder
needs to be oriented under the pulley. Easi-
est way is to lay the assembled pole on the
ground pulley facing up towards the sky.
Measure from the bottom up to around 50”.
Your rope winder has been assembled for
you. Loosen and remove one of the whiz
Troyer’s Birds’ Paradise 20785 Morris Rd Conneautville, PA 16406 814-587-2756 Page 3
Step 3B
Step 3C
Step 3C
Step 4
Step 4
Step 6
Step 3C
