Troy Custom Detectors Shadow X3
38
Battery Door:
Weatherproof with Positive Lock Fastener
Battery Test:
On-Demand with Variable Audio Tone
Control Housing:
Internal RFI Shielding and Weatherproof
Pushbutton Pinpoint Switch:
Weatherproof
Toggle Switches:
Weatherproof With Internal 0-Ring in Actuator
Control Knobs:
With O-ring & Tension Adjustable
Optimum Temperature:
20 to 110 degrees F
Optimum Humidity:
0 to 100% R. H.
Rod Design:
3-Piece with snap-button and camlock stabilizers
Arm Cup:
Foam-Padded Adjustable – Forward & Backward and To Arm Size
Warranty:
Limited Lifetime
SPECIFICATIONS
- continued
¢
¢
7
Owner Instruction Manual
Assembling your Shadow X3 metal detector is a simple and easy task
that should take only a few minutes to accomplish. – No special tools
are required.
The search coil is shipped already attached to the lower stem (pole). All
that is required to complete assembly is to attach the lower stem to the
upper S-pole/control box assembly.
Carefully unpack and save the shipping box for storage or future ship-
ment. Your box should contain:
1.
SEARCH COIL
- With coil-mounting hardware – bolt, nut and two
rubber friction washers - Factory assembled.
2.
POLE
- The pole assembly consists of a lower and upper half.
3.
BATTERY
- One 9-volt Alkaline type - Factory installed.
If any of these items are missing, immediately contact the Troy Author-
ized Dealer where your detector was purchased.
„
ASSEMBLY
u
Unscrew the silver-metal coil connector locking collar (turn counter-
clockwise) and temporarily disconnect - by gently pulling outwards - the
coil connector from the rear of the control-box housing.
v
Loosen (turn counterclockwise - as viewed from the operating posi-
tion) both plastic camlocks on the upper and lower poles.
w
Insert the lower stem with attached coil into the upper pole assembly
by pressing and holding the silver snap-button. As you slide the pole into
the upper pole, guide it to drop the snap-button through the fourth
(middle position) snap-button hole.
x
Hold the detector as you would while using it and adjust the shaft
length to match your height and stance by pressing in on the snap-
button and moving the lower pole to the most suitable hole position for
you.
ASSEMBLY
¢
¢
