4mm
4
Wood dowel (4x30mm)
Wood dowel (4x30mm)
Rib template (2mm ply)
Drill two holes at the stabilizer root base via rib template
and epoxy the wood dowel in them.
1mm
Elevator
Tailing
edge
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between
elevator and tailing edge.
Trim slot to appropriate position in the stabilizer .
Apply instant type CA glue to elevator and pin hinge.
Assemble the stabilizers carefully to the fuselage.
4mm
Rib template (2mm ply)
1
Rib template (2mm ply)
1
Stab joiner (12x310mm)
Stab joiner (12x310mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
1x20mm
Make sure hinges are
mounted in the same line.
3mm
6
Pin hinge(24x24mm)
According to the rib template drill holes to the tail of
fuselage and assemble the "U"style wire as illustration.
39
42
41
8
40
38
43
Elevator servo
Glue the elevator to the stabilizer by CA and epoxy.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Install the servo.
4
Plastical tube(3x30mm)
2
Steel wire (0.5x3000mm)
2
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x80mm)
4
Copper joiner
3
Pin hinge(2.5x48mm)
Make sure hinges are
mounted in the same line.
Drill holes to appropriate position in the rudder and epoxy
the ping hinges in them
30mm
25mm
80mm
2.5mm
3
Pin hinge(2.5x48mm)
2
Clevis
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Assemble the elevator sever to appropriate position
in the fuselage.
Connect the elevator and the serer via the steel wire.
45
46
47
9
48
44
Accessory list for the coming installation steps.
