5mm
20mm
170mm
20mm
Drill holes to relevant position on the fuselage and
epoxy the dummy bomb in it steadily.
Epoxy the small fairings to appropriate position
on the fuselage.
Epoxy the PVC to the ply and glue it to the fuselage
as illustration.
Top view
Position for
right diagram.
ELEVATOR
Side View
20mm
20mm
5mm
4mm
Epoxy the wire to the relevant holes as illustration.
113mm
15mm
Trim the dummy radiator careful along the shaded line
and epoxy it to relevant position on the fuselage.
1
Metal wire
Adjustment.
84
83
85
86
87
88
16
Accessory list for the coming installation steps.
1mm
Aileron
Trailing
edge
Make sure they are in
the right position while
installing.
Make sure hinges are
mounted in the same line.
6
Pin hinge(24x24mm)
8
6
2
2
2
4
2
2
2
2
Clevis
Rod (2x300mm)
Retainer
TP Screw (2.3x12mm)
Wooden Block(20x20x8mm)
Servo tray(68.5x56.5x2mm)
Pin hinge(24x24mm)
Screw (3x40mm)
Washer(3x15mm)
2
Washer(3x15mm)
Lock Nut (3mm )
Clevis
Retainer
Rod (2x300mm)
Screw (2x10mm)
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Install the nylon control horn and connect the linkage.
Install the servo as the illustration below
Apply instant type CA glue to the aileron of top
wing and pin hinge..
Keep 1mm width space between aileron and trailing edge.
Assemble the aileron to main wing with instant
type CA glue.
1
2
3
4
5
1
Accessory list for the coming installation steps.