A
A’
B
B’
B = B '
A = A '
2
Wood dowel (6x50mm)
2
2
Blind Nut (6mm)
Screw (6x50mm)
1
Gear door
2
Wheel (100mm)
2
LockNut (4mm)
4
Bushing (8X4mm)
6
Ply(9mm)
2
2
Ply(3mm)
TP Screw (3x20mm)
TP Screw (2.3x8mm)
Retracts strut
LockNut(4mm)
Bushing (8X4mm)
Spring
2
Ply(3mm)
Pleas clear the appropiate position before epoxy the
plies in it.
Bushing (8X4mm)
Screw (2x10mm)
TP Screw (2.x10mm)
Pin hinge(36x20x1mm)
Pin hinge
8mm
Note:rubber wheels oleo struts
and retracts are optional.
Nut(2mm)
4
Nut (2mm )
12
Washer(2x5mm)
Washer(2x5mm)
4
Screw (2x10mm)
55mm
50mm
Center
line
1.5mm
8
TP Screw (3x20mm)
4
TP Screw (2x10mm)
2
Spring
（
3X20mm
）
Assemble the gear doors and the wheels to the retracts.
Assemble the the retract.
Accessory list for the coming installation steps.
Epoxy the pliies to appropriate position for assembling
the retracts
Assembly of the main wings
Drill two holes for pulling out the servo extension line.
4
21
20
19
17
18
Set Screw (3x4mm)
Set Screw (2mm)
Rod (2x400mm)
Set Screw (2mm)
Washer (2mm)
Linkage Stopper
1
1
1
1
1
4
4
Washer (4x8mm)
4
Rod (2x400mm)
Blind Nut (4mm)
Screw (4x25mm)
Set Screw (3x4mm)
Fuel supply line
Fuel spray line
Air pressure line
4
Blind Nut (4mm)
Washer (4x8mm)
Nut (4mm)
Spring Washer (4mm)
Washer (4x8mm)
Screw (4x35mm)
Washer (4x8mm)
Screw (4x25mm)
5.2mm
Blind Nut
4mm
Epoxy the fuel tank in the fuselage.
Assemble the throttle linkage.
The sketch map when the engine install completion.
Assembly of the fuel tank.
Drill four holes at the diameters as shown for engine
mount.
Assemble the engine.
9
49
48
47
44
45
46
