Armado e Instalación
3
7
Montaje
Las referencias al lado derecho o izquierdo de la cultivadora se
determinan desde la posición del operador.
Manija
1.
Identifique los cables del embrague de marcha directa y de
marcha atrás. Consulte la Figura 3-1.
Cable de embrague marcha directa
Cable de embrague de
marcha atrás
Figura 3-1
NOTA:
Asegúrese de no torcer los cables mientras realiza la instalación.
2.
Enganche el extremo "Z" del cable del embrague de marcha
directa (A) en la palanca de enganche de los dientes de marcha
directa. Consulte la Figura 3-2.
A
B
Figura 3-2
3.
Enganche el extremo "Z" del cable del embrague de marcha
atrás (B) en la palanca de enganche de los dientes marcha atrás.
Consulte la Figura 3-2.
4.
Retire el perno hexagonal y la arandela cónica del lado derecho
del bastidor. Sostenga la ménsula de la guía del cable del lado
izquierdo del chasis ya que se caerá al quitar el perno. El Paso 1 en
la Figura 3-3.
1
2
3
Figura 3-3
5.
Inserte la manija en el bastidor de la cultivadora según se muestra
en el Paso 2 de la Figura 3-3.
6.
Inserte el perno a través de la arandela cónica, el bastidor, la
manija y dentro de la ménsula de guía del cable (observe que la
muesca de la ménsula de la guía del cable pasa por encima de la
brida sobre el bastidor). El Paso 3 en la Figura 3-3.
Contenido de la caja
•
Cultivadora (1)
•
Conjunto de barra de control (1)
•
Conjunto de calibre de profundidad (1)
•
Manual del Operador (1)
•
Manual del Operador del Motor (1)
•
Botella de 20 onzas de aceite 10w30 (1)