Trox Technik TAP-L, Руководство по эксплуатации

Страница: 16 / 28

5 Software use
5.1 Control elements and status LEDs
Fig. 12: Status LEDs
1 Mains isolator
2 Filter change alert
3 Controllers
Mains isolator (green)
The mains isolator is used for switching the unit on or off
Status LED:
Off - Unit is switched off or there is no
supply voltage.
Permanent
light, green
- Unit is switched on, supply voltage is
applied.
Filter change alert (red)
Off - Unit is working properly.
Lights up red - Filter dirty, filter must be changed.
Digital display of control
Display Description
qv [m³/h] Volume flow rate actual
value (air change rate)
Setpoint 1 [m³/h] Volume flow rate setpoint
value (air change rate)
Range qv [m³/h] Maximum controllable
volume flow rate
Vout [V] Actual value of the output
voltage
Δ
[Pa] Actual value of the differ-
ential pressure
Time not used
UNICON CPGxxx-AVC Software version
It is possible to scroll through the display using the ▼ /
▲ keys
5.2 Starting
Prerequisites:

Filters must be inserted and in proper condition.

Door closed.

Air inlet and air outlet must be free.
1. Plug in mains plug.
2. Switch the unit on at the mains isolator
( Fig. 12 /1).
ð
After switching on (if mains voltage is applied
to the unit), the green indicator lamp on the
mains isolator lights up.
When the unit is switched on, the fan speed is
slowly increased (starting time 2-3 min). The
unit is hardly audible, due to the very good
sound insulation properties.
5.3 Operation
The door must remain closed during operation, other-
wise the indoor air flowing in through the door will not be
filtered.
The fan can also pulsate when the door is open. As
soon as the door is closed, the fan runs properly again.
5.4 Switching the unit off
Use the mains isolator to switch off the unit
( Fig. 12 /1).
ð
If necessary, pull out the mains plug, e.g.
during maintenance work or longer interrup-
tions in operation.
Software use
Switching the unit off
TROX AIR PURIFIERS TAP-L  TAP-M 16