EN
9
fan heater TFC 21 E
No.
Designation
Meaning
17
ECO mode
button
Switching the ECO mode on or
off
Set the desired room
temperature (15 °C to 35 °C)
18
Increase value
button
Set the desired room
temperature (15 °C to 35 °C)
or increase the set number of
hours when the timer is
activated
19
Decrease value
button
Set the desired room
temperature (15 °C to 35 °C)
or reduce the set number of
hours when the timer is
activated
21
Timer
button
Switching the timer function on
and off:
1 h to 24 h in increments of
1 h
22
Oscillation
LED
Is illuminated when the
oscillation function is activated
23
Illumination
button
Switching illumination of the
display on or off
24
Frost monitor function
LED
Is illuminated when the frost
monitor function is activated
25
Segment display
Indication of the desired
temperature and/or the set
number of hours of the timer
26
On/off
button
Switching the device on or off
27
Temperature
button
Decreasing or increasing the
desired room temperature
(15 °C to 35 °C)
28
Timer
button
Switching the timer function on
and off:
1 h to 24 h in increments of
1 h
Decreasing or increasing the
set number of hours of the
timer
Info
After approx. 1 minute without any input, the display is
dimmed automatically.
Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
1. Set the mains switch (
7
) to position
I
.
ð
The device is now in standby mode.
2. Press the
On/Off
button (
26
).
ð
An acoustic signal is emitted.
ð
The room temperature set is indicated on the segment
display (
25
).
ð
The device is switched on.
Setting the operating mode
The device comes with the following operating modes:
•
Heating function
•
Frost monitor function
•
ECO mode
Heating function
Please proceed as follows to activate the heating function:
ü
The device is switched on.
1. Press the
Mode
button (
12
) until the LED for the desired
heating level is lit.
ð
The heating level selected is activated and the device
starts to heat.
Heating level 2
is activated with a delay
of 10 seconds.
Frost monitor function
ü
The device is switched on.
1. Press the
Mode
button (
12
) until the
Frost monitor
function
LED (
24
) is lit.
ð
The device automatically maintains the temperature at
7 °C. This temperature cannot be changed.
Saving mode (ECO)
ü
The device is switched on.
1. Press the
ECO mode
button (
17
) .
ð
The
ECO mode
LED (
16
) is lit.
ð
The device adapts the heating level automatically to the
room temperature.
ð
The device automatically operates at
Heating level 2
if
the room temperature is 18 °C or below.
ð
The device automatically operates at
Heating level
1 if
the temperature is above 18 °C and below 25 °C.
ð
The device stops heating automatically if the room
temperature is above 25 °C.
Note
The temperature settings cannot be changed in this
operating mode.
