EN
Operating manual – Material moisture measuring device T510
6
Performing the building moisture measurement
Danger!
When handling the device there is a risk of injury due to
the exposed measuring tips.
Always put on the protective cap when not in use.
Caution!
Never force the measuring device into the material to
be measured or yank it out. Applying force can lead to
bending or breaking of the measuring tips.
Requirements
:
• The device is switched on.
• The measurement type for building moisture is set.
1. If possible, prick the measuring tips a few millimetres into the
material.
2. Read the measured value from the lower measurement value
display.
– For measured values of less than 15 digits the display
reads:
----
.
– For measured values above 100 digits the display flashes.
3. Carefully pull the device out of the material by gently moving
it in turns to the left and to the right.
Key lock
1. Briefly press the On/Off key (4) during operation.
– The device emits a short beep.
– The following message appears on the display: LoC on.
– Key lock is activated.
2. Press the On/Off key (4) again.
– The device emits a short beep.
– The following message appears on the display: LoC off.
– Key lock is no longer activated.
Configuration mode
1. Press the Left/menu key (11) for approx. 2 seconds.
– The device emits a short beep.
– The CFG symbol (12) is displayed in the upper right corner.
2. Use the Right/back or Left/menu key to choose from the
available settings.
– Please note that some of the settings can only be selected
with a certain measuring mode.
Setting the type of measurement
Here you can determine whether you want to measure wood or
building moisture. You can choose from the settings
Wood 120
and
Build 100
.
1. Select SENS (18).
2. Press the OK button (10) for approx. 2 s to confirm.
– The upper and lower measured value displays are flashing.
3. Use the Up or Down key (9) to select the measurement type.
4. Press the OK button (10) for approx. 2 seconds.
– The type of measurement was set based on your choice.
– The device switches to measuring mode.
Note
:
How the measured values are indicated, changes depending on
the type of measurement.
• Wood moisture:
– Upper measurement value display: measured material
moisture in %.
– Lower measurement value display: preset material tem-
perature in °C or °F.
• Building moisture:
– Upper measurement value display: no indication.
– Lower measurement value display: measured material
moisture in digits.
Configuration
mode
Description
Lamp
Setting brightness.
Available are values between 20 and 100 % and AL.on.
Switch-off after 30 min unless with setting AL.on.
SENS
Selecting the sensor mode, available settings are Wood
and Build.
MAT
Only available in sensor mode Wood.
Selection of different wood types, see table of wood types.
TEMP
Only available in sensor mode Wood.
Setting the value for wood temperature (fixed value only,
no measurement, value range between -20 and +60 °C).
Alarm
Setting the alarm value.
value range: 0 to 100 digits or M%
CAL
Setting the offset value.
Will be added to the measured value.
value range for the wood moisture measurement: -50 to
+50 M%
value range for the building moisture measurement: -50 to
+50 digits
TH
HOLD
%WT
g/m
3
g/kg
Pabs[hPa]
SENS
MAT
TEMP
Alarm
Alt.[ft]
CAL12
gr/lb dp °C °F % rH
CM
m/s
ppm °F °C
IR
MAX
DP
MIN
AVG
CFG
ACT
14
16
18
12