EN
3
battery charger PBCS 2A
•
Do not under any circumstances use the device if you
detect damages on the mains plug or power cable.
If the power cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Defective power cables pose a serious health risk!
•
This appliance is not a toy. Keep away from children and
animals.
•
Do not open the device.
•
When operating the device, observe the polarity. In the
case of reverse polarity, the reverse polarity protection
function stops the charging process from being started, in
order to prevent damage to the charger and battery.
•
Interrupt the charging process if the battery gets too hot.
For the maximum temperature, please refer to the
manufacturer specifications in the vehicle’s operating
manual.
Safety warnings on the device
The following safety instructions are additionally attached to the
device:
•
Read all safety warnings and all instructions.
•
Using the device may produce explosive oxyhydrogen gas.
Only operate the device in rooms that are well ventilated
and prevent open fire and spark formation.
•
Always remove the mains plug from the mains socket
before attaching or removing the battery terminals.
•
Do not expose the charger to rain or wet conditions.
Note regarding automatic charging
The device is provided with a microprocessor control, allowing
for automatic monitoring and adaptation of the multi-stage
charging cycle. This makes monitoring of the charging process
indispensable. Nevertheless we advise you not to leave the
battery unattended over a longer period, so that you will be able
to disconnect the device manually from the power supply in the
event of a fault.
Intended use
This device is designed for charging batteries used in vehicles.
This refers to both non-maintenance-free and maintenance-free
12 V batteries, including wet batteries like for instance lead
acid, Ca/Ca and EFB batteries as well as lead gel and AGM
batteries.
The device is suitable for indoor use as well as for outdoor areas
protected from weather conditions.
The device is only intended for private, non-commercial use.
Foreseeable misuse
The device must not be used for charging lithium iron
phosphate batteries (e.g. LiFePO4) or other rechargeable lithium
batteries.
The device must not be used to charge non-rechargeable
batteries.
The device is only intended for mobile use and not for the
installation in caravans, camper vans or similar vehicles.
The device is not intended as buffer power supply, e.g. during a
battery change.
Personnel qualifications
People who use this device must:
•
have sufficient proficiency in the field of electrics and
utilise the device performing safe working practices.
•
have read and understood the operating manual, especially
the Safety chapter.
Personal protective equipment
Wear safety glasses
Wear suitable protective goggles when using the
device.
Wear protective gloves
Wear suitable protective gloves when using the device.
