EN
17
cordless angle grinder PAGS 21-115
7. Put the cutting disc (17) on the mounting flange (15).
The labelling must point to the device. Make sure that the
cutting disc hole fits the mounting flange without
clearance. Do not use any reducers or adapters.
17
15
8. Screw the clamping nut (16) back on.
The flat side of the clamping nut must point to the device.
16
9. Press the spindle lock (1) to lock the gears.
10. Slowly turn the clamping nut (16) to the locking point until
the lock is fixed. Press and hold the spindle lock (1).
11. Retighten the clamping nut (16) by means of the face
spanner (11). Then let go of the spindle lock (1).
Pay attention not to damage the cutting disc.
1
11
16
12. Check the cutting disc (17) for proper fit.
13. Check whether the cutting disc can rotate freely. Make
sure that the disc does not touch the guard or other parts.
14. Carry out a test run of approx. 1 minute without load prior
to every disc change and every start-up in order to check
the cutting disc for correct fit.
15. Put the face spanner (11) back into the additional
handle (14) for storage.
16. Put the battery back in.
Caution
If the disc is out-of-round, rotates unevenly, vibrates,
oscillates, or if unusual noises or sparks are generated,
the cutting disc must be exchanged immediately.
Otherwise, there is a risk of injury.
