EN
7
radiant heater IRS 2010 E
Assembly and start-up
Scope of delivery
•
1 x device
•
1 x Remote control
•
1 x Foot
•
4 x Fixing screw for foot
•
1 x Hexagonal wrench
•
1 x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Remove the transport protection (
8
) from the grille of the
radiant heater.
8
4. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Assembly
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the “Installation” section in the “Assembly and
start-up” chapter and the technical data in the
“Technical annex” chapter.
Foot assembly
1. Tighten the 4 screws for the foot (
6
) on the device using
the hexagonal wrench.
2. Check the foot for tight fit.
6
