8
EN
radiant heater IR 2001
4. Position the mounting brackets of the device over the
threads of the wedge bolts and secure the mounting
brackets with the washers and the nuts.
5. Use a wrench (SW 10 mm) to tighten the nuts firmly.
6. Make sure that the device is attached securely.
7. Loosen the wing nut (
7
) and tilt the device to the desired
angle. Observe the different inclination angles.
ð
When mounting the device on a wall, only align the
device downwards at an angle of 30° to 45°.
7
ð
When mounting the device on the ceiling, only align the
device at an angle of 30° to 45° on both sides.
7
8. Once the device is at the desired inclination angle, tighten
the wing nut (
7
) again.
Start-up
Info
Odours might arise upon initial start-up or after a
longer period of non-use.
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
Make sure that there are no curtains or similar objects in
the immediate vicinity.
Connecting the power cable
•
Insert the mains plug into a properly fused mains socket.
•
Make sure that the power cable is guided along the back
of the device. Never guide the power cable along the front
of the device!
