EN
7
radiant heater IR 1500 SC / IR 1510 SC / IR 2000 SC
Assembly
The device is intended for ceiling installation. Observe the
following requirements for the installation:
Warning
Risk of fire due to improper installation!
There is a risk of fire if the required minimum
distances are not observed.
Observe the Installation chapter and the technical data
in the Technical annex.
Warning
There is a risk of the device falling down if the required
minimum carrying capacity for the ceiling has not been
observed.
Select or mount a ceiling holder suitable for the weight
of the device (see technical data) and the structure of
the ceiling. The ceiling and the holder must be able to
hold a weight 3 to 4 times heavier than the device. The
device must only be mounted to a solid ceiling surface.
1. Hook one carabiner to one end of the fastening chain and
to the bracket for ceiling mounting (1).
2. Connect the other carabiner hook with the mounting on the
ceiling.
3. Fasten the device on the ceiling by hooking one chain link
into the carabiner on the mounting on the ceiling. In doing
so, observe the minimum distances from the ceiling and to
the ground.
4. Check the clips of the carabiner hooks for closure.
5. Make sure that the on/off switch (4) is in position "
0
".
6. Guide the mains cable along the chain link and fasten the
mains cable with cable tie. Note that the mains cable must
not make contact with the device.
Installation
When installing the device, observe the minimum distances
from walls and other objects as described in the Technical data
chapter.
•
Never install the device in a way that it radiates directly
onto walls or other objects. Observe the minimum
distances from walls or other objects according to the
Technical data chapter.
•
Only install the device in a horizontal position.
A
B
C
C
