Trotec IDX 30 D, Руководство по эксплуатации

Страница: 8 / 22

7 EN Operating manual – oil heater IDX 30 D
Start-up
• Check the scope of delivery of your device for
completeness. If an accessory part is missing, please
contact the Trotec customer service or the specialist dealer
where you purchased the device.
• Check the device and its connection parts for potential
damage.
• Observe the conditions described in the chapter
Positioning.
• Fill the tank with EL fuel oil, kerosene or diesel as
described in chapter Maintenance.
• Check the device for its proper condition prior to start-up
and at regular intervals during application.
• Check whether the characteristics of the power grid
conform to those on the nameplate.
• Each time before you plug the mains plug into the mains
socket and switch on the device, make sure that the fan is
moving freely.
• Connect the mains cable to a properly secured socket. On
construction sites, there must be a residual current
device (RCD) installed upstream of the socket in
accordance with national regulations (in Germany:
VDE 0100/0105).
The device is now ready for operation.
Operation
The device may only be used by accordingly instructed persons.
Operating elements
25 30
35
40
45
5
10
15
20
13
14 15
16
No. Designation
13 Operating LED
14 Temperature indication
15 ON/OFF switch
16 Rotary control thermostat
Switching the device on
The device continues to operate until the desired room
temperature is reached.
1. Set the on/off switch (15) to position
I .
ð The operating light (13) is illuminated.
2. Set the rotary control (16) to the desired room temperature.
This value should be higher than the current room
temperature.
ð
The desired room temperature is displayed via the
temperature indication (14).
3. Ensure a successful ignition.
Switching the device off
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Notice
Damage to the device due to overheating!
Never switch off the device by pulling the mains plug.
This may lead to overheating!
Switch off the device properly. Only pull the mains plug
once the fan motor has stopped completely.
1. Switch off the device by setting the on/off switch (15) to
position 0 .
ð
The operating light (13) goes out.
2. Wait until the fan motor has come to a complete standstill.
3. Secure the device against inadvertent switch-on by pulling
the mains plug.
4. Allow the device to cool down completely.