9
EN
Operating manual – 3-in-1 multi-function sander PMSS 10-200
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Remove the tool from the tool holder.
•
If attached, disconnect the dust extraction system from the
device.
Storage
Before
storing the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Remove the tool from the tool holder.
•
If attached, disconnect the dust extraction system from the
device.
•
Clean the device as described in the Maintenance chapter.
•
For storing the device, use the transport case included in
the scope of delivery in order to protect the device from
external influences.
When the device is not being used, observe the following
storage conditions:
•
dry and protected from frost and heat
•
ambient temperature below 40 °C
•
protected from dust and direct sunlight inside the transport
case
Start-up
Unpacking the device
•
Take the transport case out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
•
Check the contents of the transport case for completeness
and look for damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
Changing the sanding plate
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Notice
The orbital sanding plate and the delta sanding plate
can only be mounted in one direction.
When mounting the orbital sanding plate, the arrow
must point to the front.
When mounting the delta sanding plate, the tip must
point to the front.
Notice
The rubber pins may only be used for the orbital
sanding plate and the delta sanding plate.
The random orbital sanding plate is preassembled.
You can change the sanding plate to carry out various activities.
