12
EN
cordless high-pressure cleaner PPWS 10-20V
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch the device off.
•
If required, allow the device to cool down.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Remove the battery from the device (see Start-up chapter).
•
Remove the lance from the device.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
Multiflex 20V 2.0 Ah spare battery 6.200.000.303
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
•
Check whether the battery is inserted correctly in the quick
charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damage.
•
Check the on-site fusing.
•
Check the quick charger for damage. If the quick charger
is damaged, stop using it. Contact the Trotec customer
service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery is empty. Recharge the battery.
Info
Wait for at least 10 minutes before switching the
device back on.
Strong pressure fluctuations:
•
The nozzles are dirty or clogged. Rinse the nozzles with
water. When cleaning the nozzle holes, you can use a
needle.
Water system leaky
•
The connections are not installed properly. Switch the
device off and remove the battery. Install the connections
properly as described in the “Start-up” chapter.
•
The connection pressure is too high. Only connect the
device to a water supply with a maximum pressure of
5 bar.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
