8
EN
soldering station PSIS 11-230V
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before
transporting the device, observe the following:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
Storage
Before
storing the device, proceed as follows:
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Allow the device to cool down.
•
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
•
Dry and protected from frost and heat
•
Ambient temperature below 45 °C
•
Protected from dust and direct sunlight
Start-up
Unpacking the device
•
Take the device and the accessories out of the packaging.
•
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
•
Dispose of the packaging material according to the
national regulations.
Inserting / changing the soldering tip
Caution
Burn hazard!
Removing the soldering tap must only be
performed if the device has been switched off and the
soldering tip has cooled down.
The soldering tip (
8
) has a screw thread which allows to quickly
and easily replace the soldering tip.
1. Hold onto the mains plug while pulling the power cable out
of the mains socket.
2. If necessary, allow the soldering iron (
9
) to cool down in
the soldering iron holder (
1
).
3. Turn the pre-mounted soldering tip (
8
) counter-clockwise
in order to unscrew it from the soldering iron (
9
).
9
8
4. Turn the new soldering tip (
8
) clockwise into the soldering
iron (
9
).
Tin-coating the soldering tip
Prior to initial start-up of the soldering station or if using a new
soldering tip, the soldering tip (
8
) must be coated with tin.
Connecting the power cable
1. Insert the mains plug into a properly secured mains
socket.
