Align
grooves
with nibs
Groove
Nib
Insert
Screw
Slide Clear Lens
under two screws
Rotate
Remove
one screw
Loosen
two screws
Align key holes to screws
Light
Pan
Rotate
Insert
Screw
7. LIGHT/COVER INSTALLATION
INSTALLATION IS COMPLETE
Remove one screw and loosen two
screws from the central hub.
Lift light pan to motor to engage the
large end of the key holes with the screws.
Rotate the plate slightly to engage two
screws in small ends of key holes.
Insert screw removed in step 1 and tighten all three screws.
7a. Installing the Light Pan
8. REMOTE SETTING
8A. Preparing Remote Control
Remove Battery Cover from Transmitter
Install 2 AAA Batteries
The model is equipped with dimmable LED array so
the Light selector switch should remain on DIM setting.
2
1
3
Off
Light
(On/Off,
hold for
Dimmer)
High Medium Low
L
E
A
R
N
S
W
IT
C
H
LI
G
H
T
ON
DIM
Light
On/Dim
Selector
8B. Remote Pairing Process
Transmitter and receiver must be paired to operate together,
or to reset after replacing either transmitter or receiver module.
(c
an also circumvent Radio Frequency Interference from another RF device.)
Pairing process is begun with power to the fan turned OFF at the breaker.
Turn on the power.
Within 30 seconds of restoring power,
press and hold the Learn Switch
button for 3 to 5 seconds,
using narrow tool, pen or pencil tip.
The light on the fan will flash 3 times when complete.
Slide the Battery cover back on.
Battery
Cover
L
E
A
R
N
S
W
IT
C
H
LI
G
H
T
ON
DIM
Learn
Switch
Battery
Cover
REMOTE FUNCTIONS
P5
Lift cover to motor, aligning
the opening of the grooves to
the nibs inside the lower plate.
Rotate cover clockwise to
secure it to motor assembly.
7d. Installing the Light Cover
Plug in
Connector
Remove
one screw
Loosen two screws
Insert screw removed in 7b
and tighten all three screws.
Remove one screw and
loosen two outermost
screws on the light pan.
Lift Clear Lens to the light pan,
sliding the notches under the
two screws.
Plug in wire connector.
7c. Installing the Clear Lens
7b. Connecting the LED
