5-3.Making electrical wire connection
The standard lead wires are for 72" downrod.
You may need to cut all 5 lead wires (from motor) in proper length & strip them for wire connection
and it is easier for Canopy installation.
Follow diagram below and make sure that all exposed wires are secured inside wire nuts or terminal block.
Note : Wires from house may vary in color and may not include ground wire (green).
After wiring is completed, gently push wires into junction box with wire nuts pointing upward.
From Remote
From House
(AC-N)
(AC-L)
White
Black
From Fan
Black
White
Black
White
Gray
Black
White
Gray
(
For motor
)
(
For motor
)
(
For motor
)
Green
( house ground wire )
Green
Green
( from Hanger Ball )
( from mounting bracket )
Blue
Blue
(
For Light Kit
)
Orange
Orange
(
For Light Kit
)
(
For motor
)
(
For motor
)
(
For motor
)
(
For Light Kit
)
(
For Light Kit
)
P5
“ Special note: All Green grounding wires, from Hanger ball/Mounting bracket/Receiver,
must be well attached to House Ground/Ear th to prevent flickering of LED. ”
*Remote
*Receiver
A
Set
B
Set
FC912RS
P13Y808082
For 3LN60
FC912RS
P13Y808082
1.SERIAL NUMBER
2.MODEL NUMBER
NOTICE
:
All remote sets for DC motor are looked the same, this remote set (Transmitter and receiver) is pre-set at factory, please
note the following before operation,
1. The serial number on transmitter and receiver must be the same.
2. The label also shows the model number on receiver.
3. Do not mix the remote sets if you are installing more than one fan.
3.Do
not
mix
5-2.Insert receiver into mounting bracket
Receiver
NOTE:
Do not squeeze all the wires while inserting the receiver into the mounting bracket.
5. WIRE CONNECTION
Mounting
Bracket
5-1. Check the serial No. & Model No. on the receiver & Transmitter
