2
Coffee, Chat, Dining Height Base Assembly
Place Table Top Frame upside down on the prepared work surface. Mounting Post should
be facing upwards.
Place one leg onto a corner mounting post aligning attachment holes in the leg to the holes
in the mounting post.
Attach leg with two bolts and two
washers and fully tighten. Repeat for the
remaining three legs.
Check 8 bolts to ensure that all are fully
tightened.
Counter, Bar Height Base Assembly
Place one leg onto the Cross Brace at
mounting bracket.
Loosely attach with two bolts and two
washers. Do not fully tighten at this
point. Repeat process until all four legs
are loosely
attached to the Cross Brace.
Place Table Top Frame upside down on
the prepared work surface. Mounting
poata should be facing upwards.
With the Cross Brace attached, place
the four legs onto the four corner
mounting posts of the Table Top Frame.
Loosely attach each leg with two bolts
and two washers. Do not fully tighten
until all four legs are attached.
Fully tighten all bolts. Check 16 bolts to
ensure that all are fully tightened.
3
Step 1
CAUTION: It is the assembler’s and user’s responsibility to
confirm and install proper length screws to prevent damage
to the Top.
Place one screw into the Table Base. Measure the length of the
screw threads to insure they stick up 3/8” –1/ 2”.
x
If the screw sticks up more than 1/2”, do NOT proceed. The screws are too
long and will stick up through the Top surface.
x
If the screw sticks up less than 3/8”, do NOT proceed. The screws are too
short and will not properly secure the Top.
Step 2
Prepare a smooth, non-scratch work surface (shipping container, a tarp or pool towels can
be used). With two persons, place the Table Top upside down on the prepared work
surface. With two persons, gently place the Base upside down onto the Top.
Step 3
Tops with Umbrella Hole
Center the Base on the underside of the Top; sight down through the umbrella support ring
in the Base and align it to the Top.
Square, Rectangular
Tops: Align the Base to the corners of the Top.
Round
Tops: Continue to step 4.
Tops without Umbrella Hole
Center the Base on the underside of the Top.
Square, Rectangular
Tops: Align the Base to the corners of the Top. Measure
equal distances at (4) places from the corner of the Top to the leg mount.
Round
Tops: Measure equal distances at (4) places from the edge of the Top to
the leg mount.
Step 4
Attach the Base to the Top using the supplied screws at (8), (12) or (16) places.
NOTE: After assembling one Table, turn the Table upright. Confirm the screws have
not penetrated up through the top surface.
With two persons, lift the table upright while holding the Base near the (4) outermost Base
to Top connection points.
Check that all the screws are firmly tightened at (8), (12) or (16) places to retain the Top.
