3
Step 2
With 2 persons, place the Table Top
upside down on the prepared work
surface.
With 2 persons, place the
assembled legs upside down (glide
feet up) onto the Table Top leg stub
mounts.
Loosely install the screws and
washers securing the Legs to the
Top (2 screws per leg).
If you aren’t able to get the screws
started on the first try, put one hand
on the glide (at the top of the leg)
and adjust / wiggle the leg while you
hand-start the screw.
After all screws are loosely installed,
fully tighten the screws securing the
Legs to the Top (4 places, 8
screws).
Step 3
Fully tighten two bolts, flat washers
and nuts to attach the Leg Support
Brace to all the Legs
(4 places, 8 bolts).
Step 4
With two persons, turn the table upright. Position the table for use
and enjoy!
4
4011xx Banchetto KD Table
“U” MOUNT
Step 1
Place the Table Top upside down on the prepared work surface.
Loosely attach (3) Legs with bolts, flat washers and nuts
(3 places). Mounting posts on legs point inwards.
Bolts will fit tightly into holes. You can thread the bolt into the
holes if necessary.
Don’t fully tighten the bolts until Step 5.
Step 2
Place the Leg Support Brace onto the Leg mounts with welds
facing up (downwards when upright). For oval and rectangular
tables, start with two legs on a short side (closer together).
This is a tight fitting connection; you may need
to “bump” the leg with the heel of your hand to
fully seat the Brace.
Parts List
See page 1.
