Trophy 1703, Дополнение к руководству пользователя

Страница: 55 / 96

49
Center Console Models
•
Owner’s Manual Supplement Chapter 7: Plumbing
1903 Baitwell & Seawater Washdown System
Filling & Using the Baitwell
1. Insert the rubber end of the drain
standpipe into the drain fitting at the
bottom of the tank.
2. If equipped, turn the y-valve to the
baitwell position.
3. If necessary, Open the seawater
intake seacock.
4. On the main switch panel turn On the
baitwell switch.
•
Remove the standpipe to drain the
baitwell.
Aeration Tips
The level of aeration is controlled by the
aerator control valve.
•
In clean ocean water little or no aera-
tion is needed.
•
In brackish back waters a higher level
of aeration may be needed.
Troubleshooting
If you followed the instructions in steps 1
through 4 above, but water does not
pump into the tank, possible causes are:
•
The seacock is Closed.
•
A hose is collapsed or there is clog-
ging debris in the system.
•
The y-valve (if equipped) is turned to
the wrong position.
•
The baitwell circuit breaker needs to
be reset.
Seawater Washdown System (If
Equipped)
1. Turn the y-valve to the washdown
position.
2. If necessary, Open the seawater
intake seacock.
3. On the main switch panel, turn On
the baitwell switch.
SEAWATER INTAKE PUMP
BAITWELL TANK
BAITWELL
DRAIN
SEAWATER WASHDOWN
DECK FITTING (IF EQUIPPED)
DRAIN
THRU-HULL
BAITWELL TANK
AERATOR VENT
DECK FITTING
AERATOR
CONTROL
VALVE
SEAWATER
SEACOCK
SEAWATER
INTAKE PUMP
STAND-PIPE
BAITWELL & SEAWATER
WASHDOWN Y-VALVE
NOTE: VIEW IS UNDERSIDE OF DECK
INTAKE
BAITWELL/SEAWATER
WASHDOWN Y-VALVE
(IF EQUIPPED)
SEAWATER
WASHDOWN
DECK FITTING
(IF EQUIPPED)
(IF EQUIPPED)