battery terminals will pass during battery replacement.
ATTENTION:
Remember to take note of the polarity of the wires and
not interchange them. Otherwise, the unit will be damaged. Black wire
is for the negative (–) terminal and red wire is for the positive (+)
terminal.
12.
Place back the cover. Reinsert and tighten all screws.
Dispose replaced batteries properly.
Deliver the battery to its
manufacturer for recycling.
Troubleshooting
Refer to the table below to address minor problems regarding installation
and operation of Tronix Explorer XT. For problems that cannot be solved
using the table, contact Innovatronix Customer Service (see
Contact
Information
).
Problem
Possible Cause
Solution
No Power
Battery Empty
Charge Battery; Plug Tronix Explorer XT
to a 100 to 240V AC outlet or to a 14V
DC supply. If the Tronix Explorer XT does
not switch on after charging, contact
Innovatronix Customer Service (see
Contact Information
)
Not Charging
Not Plugged to
Supply
No Power from
Supply
Plug Tronix Explorer XT to a 100 to 240V
AC outlet or to a 14V DC supply
Ensure power is in the mains supply
outlet. If Tronix Explorer XT still does not
charge, contact Innovatronix Customer
Service (see
Contact Information
)
Lighting
equipment
not working
Battery not charged
Lighting equipment
malfunctioning
Incompatible
equipment
Charge Battery; Plug Tronix Explorer XT
to a 100 to 240V AC outlet or to a 14V
DC supply
Contact manufacturer of lighting
equipment
Lighting equipment not compatible with
Tronix Explorer XT (see attached
Compatibility Chart
for compatible
equipment)
Battery draining
fast
Battery not fully
charged
Modeling lamps in
Charge battery for 3 to 5 hours (12 to 15
hours if charging for the first time)
Modeling lamps, when used with flash
