Tronair 06-5009C Series, Руководство по эксплуатации и обслуживанию, Страница: 5 / 17

Model: 06-5009CSeries
(06-5009C6500, 06-5009C6600, 06-5009C6800, 06-5009C6600-A1)
Fluid Service Unit
04/2020 | Rev. 22 Page | 2
3.0 PREPARATIONS FOR USE
The unit is shipped fully assembled, and only the following steps are required to make it operational
NOTE: Apply appropriate fluid label to top of reservoir near fill opening.
CAUTION!
Only use the type of fluid for which the unit is designed. Using other fluids will cause contamination and
seal deterioration.
1. Remove the fill cap and fill reservoir
4.0 TRAINING
4.1 TRAINING REQUIREMENTS
The employer of the operator is responsible for providing a training program sufficient for the safe operation of the unit.
4.2
TRAINING PROGRAM
The employer provided operator training program should cover safety procedures concerning use of the unit in and around the
intended aircraft at the intended aircraft servicing location.
4.3
OPERATOR TRAINING
The operator training should provide the required training for safe operation of the unit.
NOTE: Maintenance and Trouble Shooting are to be performed by a skilled and trained technician.
5.0 OPERATING INSTRUCTIONS
CAUTION!
Do not use this unit on closed hydraulic systems.
To use your Fluid Service Unit, follow the steps below:
1. Open ball valve on hose end to deflate pressure from vessel.
2. Close ball valve on hose end.
3. Fill vessel with proper hydraulic fluid.
4. Attach air supply hose to air valve.
5. Pressurize vessel to 85 psig (6 bar) maximum and remove air supply hose from air valve.
6. Transfer hydraulic fluid by opening needle valve on hose end.
6.0 MAINTENANCE
6.1 FILTER
The filter is of a non-bypass design. This means that if the filter becomes clogged, no fluid will pass to the aircraft. If this
happens, replace filter element.
Element replacement schedule should be based on usage and actual fluid samples. For units with low usage, element should
be changed at least once annually.
7.0 PROVISION OF SPARES
7.1 SOURCE OF SPARE PARTS
Spare parts may be obtained from the manufacturer:
TRONAIR , Inc. Telephone: (419) 866-6301 or 800-426-6301
1 Air Cargo Pkwy East Fax: (419) 867-0634
Swanton, Ohio 43558 USA E-mail: sales@tronair.com
Website: www.tronair.com
7.2
RECOMMENDED SPARE PARTS LISTS
Reference the following page(s) for Replacement Parts and Kits available.
8.0 IN SERVICE SUPPORT
Contact Tronair, Inc. for technical services and information. See Section 1.3

Manufacturer.