Tronair 02-7815C0110, Руководство по эксплуатации и обслуживанию, Страница: 6 / 69

Models: 02-7815C0110, 02A7815C0110, 02A7848C0120
10 Ton (9.07 Metric) Two Stage Jack with Air Pump
07/2021 | Rev. 06 Page | 3
5.0 OPERATION
The user should be familiar with the following statements prior to using the jack.
CAUTION!
1. NEVER put hands between aircraft and jack pad. Aircraft struts may hang up and allow aircraft to
suddenly drop.
2. NEVER align jack under aircraft by pounding on jack legs. Dented legs may lead to jack collapse.
3. ALWAYS lower ram locking nut(s) as aircraft is raised. Be sure ram nut(s) is seated fully after jacking.
4. ALWAYS raise and lower jacks simultaneously so that aircraft remains level.
5. ALWAYS use a tail or nose stand for additional stability.
WARNING!
When collapsing rams by hand miss-staging may occur and cause pinch points. To collapse ram, add a
minimum 50 lb load to the mechanical extension. Keep hands and fingers clear of locking nuts. Failure to
adhere to this safety instruction can cause injury.
5.1
JACK INSTRUCTIONS
To Raise Aircraft:
1. Place jack on a hard, level surface.
2. Raise mechanical extension as close to aircraft jack pad as possible.
3. Close pump release valve and operate pump.
WARNING!
The locking pin MUST be placed in the ram protection ring groove and fully through the mechanical
extension.
The locking pin washer and ball lock MUST be placed outside the ram protection ring.

Visually inspect the jack prior to every use.

Do not place extra locking pins in any other hole on
the mechanical extension.

Insure mating surfaces to jack point are free of
debris and damage.

Under no conditions should the locking pin washer
or washer groove be inside the ram protection ring
groove.

Under no conditions should the lock
ing pin’s ball
lock be inside the ram protection ring groove.

Never use the jack if the ram protection ring is not
installed.

Never use the locking pin without a locking pin
washer.

Never use a locking pin that has been damaged.

Never use a ram protection ring that has been
damaged or deformed.

Replace ram protection ring if it does not have a
radius groove for the locking pin.

Load test jacks annually.

Only order replacement parts from Tronair.

Failure to comply could result in premature failure
below certified weight and could cause serious injury including death.