QUATTRON VSB
SMATV Modulator
7
Sign
Item Name
Description
B1 – B8
AV Inputs
8 pairs of RCA connectors which the cables from
satellite receivers, computers, security cameras etc.
are connected.
A: Audio
V: Video
B9
AC Power In and Power Switch
AC power input socket (male) and simple power
switch. Under the cover in the middle of this part,
there is located the high current protection fuse of the
device and its spare. When replacing it with a fuse
other than its spare, make sure that it has the same
voltage and current rating.
7. Installation Steps
1.
Securely mount your Quattron VSB device inside a 19" rack carrier (cabin).
2.
If this device is not the first device in your Headend system, remove the 75 ohms line
terminator at the RF input connector. Instead, connect the RF coaxial cable incoming from
previous device.
3.
Connect the beginning of distribution system or the coaxial cable connected to the RF input
of next device to the RF output connector.
4.
Connect the AV cables coming from video and/or audio sources to related connectors at the
rear panel.
5.
Connect the power cable with plug to an outlet with appropriate voltage and current and to
the AC Power Input at the rear of Quattron VSB, then power on the device via power switch
on rear panel. There is 3 seconds delay during boot-up.
6.
After setting the device with correct TV channel parameters, Quattron VSB could output
audio and video channels to your distribution system or to your television. You can find and
save the channels outputted from the device by performing a channel search on your
television.
8. General Viewing and Basic Operations
After you have installed and connected the cables of the Quattron VSB, power on the device
from the power switch located on the rear panel. Normally, Quattron VSB will operate stable
forever. This state is called
General Viewing
. In the General Viewing state, LCD display of the
device shows “
OPERATING...
” text. But, for the device outputs desired channels to your TV
distribution system or television, it must be properly set up and configured. Setup operations are
explained in the section “
9. Device Setup
”.
The LCD display on the device shows the running state, configurations made and its steps.
While configuring the device, a blinking cursor will appear in the menus and it will indicate the item
you are working on. Function buttons carries out usually these works while navigating through
menus:
: Alters the value of item which the cursor is over.
: Moves the cursor over previous item.
Содержание Quattron VSB Full 1-2
Страница 2: ......
Страница 11: ...QUATTRON VSB SMATV Modulator 11...