Trojan SPIRIT 200, Инструкция по уходу и руководство по сборке

Страница: 9 / 24

1560-9
7. MAINTENANCE
RUNNING BELT NOT CENTERED
• If the running belt is not centered on the tail roller and it’s either
too far left or right, please turn off the treadmill first.
• Use 6mm Allen Wrench shaped wrench to loosen bolts within
rear adjusting boxes.
• If the running belt is tracking to the left, adjust belt to track to the
right. Tighten the left tail roller Allen screw by turning quarter
clockwise. The same procedure applies if the belt is pulling right
i.e. tighten right tail roller. Power on the treadmill after
the adjustment. If it has no obvious effect, just repeat the steps
above.
• Do not use the treadmill until the running belt returns
to the center position. Should tracking occur please use the
above mentioned steps to rectify the issue.
• Please note: The running belt might not stay precisely in the
center, but might move slightly to either the right or left side.
• When aligned properly the belt wont scratch the side rails.
LUBRICATION
• It is strongly suggested that you follow the timetable below to
apply lubrication to the running deck.
• Firstly use the 6mm wrench to loosen the bolts within the rear
adjusting boxes, pull up the running belt and evenly apply
lubrication on the center deck.
• Then adjust the belt to the center of deck and following the
above step to tighten the belt.
• Please run treadmill at low speed, after all bolts are secure, to
allow equal distribution of the lubricating oil.
• Please follow the above steps to lubricate the belt if you
experience any skid phenomena.
LUBRICATION TIMETABLE
Speed Suggested Time
1~6 km 1 year
6~12 km 6 months
12~16 km 3 months