24
MAINTENANCE
CLEANING
The Trojan Ignite 350 Treadmill can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the Trojan Ignite 350 Treadmill
after each use.
Please inspect all assembly bolts and pedals on the machine for proper tightness before use.
STORAGE
Store the Trojan Ignite 350 Treadmill in a clean and dry environment away from children.
BELT ADJUSTMENT
Belt adjustment and tension performs 2 functions: adjustment for tension and centering. The
running deck has been adjusted properly at the factory. However transportation, uneven flooring
or other unpredicted reasons could cause the belt to shift off centre resulting in the belt rubbing
with the plastic side rail or end caps and possibly cause damage. To adjust the belt back to its
proper position please follow the directions below.
Your Trojan Ignite 350 Treadmill should require little maintenance other than to periodically apply
lubricant.
Lubricating under the running deck will ensure superior performance and extend the Trojan Ignite 350
Treadmill’s life expectancy.
BELT TRACKING ADJUSTMENT
If during use you notice that the running belt either shifts
to the right or the left of center, first remove the “Safety
Key” and unplug equipment from AC power source. Using
Hex Wrench provided, turn left rear roller adjustment
clockwise no more the 1/4” of a turn. Remove Hex Wrench,
insert “Safety Key” and insert AC power cord into AC outlet.
Turn on your Trojan Ignite 350 Treadmill and observe after
running for a few minutes to see if the problem has been
corrected. This may take several adjustments, so repeat
the above procedure.
HOW TO CHECK RUNNING DECK FOR PROPER LUBRICATION
Lift 1 side of the running deck and feel the
top surface of the treadboard.
If the surface is slick to the touch, then no
further lubrication is required.
If the surface is dry to the touch, apply 1
packet of lubricant or half of the bottle of lubricant.
Содержание IGNITE 350
Страница 9: ...9 EXPLODEDDRAWING...
Страница 10: ...10 EXPLODEDDRAWING...
Страница 17: ...17 REFER TO THE BELOW PROGRAM FIGURES FOR THE PRESET VALUES CONSOLEFUNCTIONS...
Страница 18: ...18 CONSOLEFUNCTIONS...