IDENTIFYING COMPONENTS FOR CAMERA UNIT
The camera unit should be disassembled when it is
installing. The names for every component are (Fig. 2):
-
CAM Base (F)
-
Camera (G)
-
CAM Rotating Housing (H)
-
CAM Tighten Ring (I)
F. CAM Base
G. Camera
H. CAM Rotating Housing
I. CAM Tighten Ring.
Fig. 2
WALL MOUNT INSTALLATION PROCEDURE
1
Use CMP (B) as template to drill 5 mounting
holes on the wall. Cut a Ø35 mm to Ø38 mm
(Ø1.375" to Ø1.5") hole for the BNC connector
to pass through (Fig. 3).
2
Insert 5 Anchors into the mounting holes. Use
Self-tapping Screws to mount the CMP (B) on
the wall (Fig. 4A).
3
Remove the CAM Base (F) from Camera Unit
(A) (Fig. 2).
4
Find the tab with triangular mark (arrow 4b) on
the back of the CAM Base (F). Align the
triangular mark (arrow 4b) with the hollow
arrow on the CMP (B) and push 3 tabs into the
slots (Fig. 4C)
5
Turn the CAM Base (F) in clockwise direction
until it is stopped.
6
Insert and fasten the Flat-head screw (E) into
the hole with the triangular mark on the front of
the CAM Base (F) to secure the Base to CMP
(Fig. 5).
7
Re-assembly the Camera Unit (A).
Now, the installation is completed.
Fig. 3
Fig. 4A
Arrow 4a
Arrow 4b
Fig. 4C
Fig. 4B
CMP (B)
CAM Base (H)
Fig. 5
3
