Maintenance
163
Battery Installation
Warning
Make sure that the battery terminals
do not touch the motorcycle frame.
This may cause a short circuit or spark
which would ignite battery gases
causing a risk of personal injury.
To install the battery:
• Place the battery in the battery
case.
• Reconnect the battery, positive
lead (red protective cover) first and
tighten the battery terminals to
4.5 Nm.
1
4
2
3
1. Positive (+) terminal
2. Battery strap
3. Battery cover
4. Negative (-) terminal
• Apply a light coat of grease to the
terminals to prevent corrosion.
• Cover the positive terminal with the
red protective cap.
• Refit the battery cover.
• Refit the battery strap.
3
1
2
1. Tool kit tray (if fitted)
2. Diagnostic connector
3. Tool kit tray fixing
• Lower the tool kit tray (if fitted)
into its original location. Refit and
tighten the tool kit tray fixing.
• Place the diagnostic connector and
any other loose items securely in
the tool kit tray.
• Refit the rider's seat, see page 87.
• Refit the passenger seat, see
Содержание Tiger 900 GT
