General Information
105
To refit the seat:
• Reconnect the heated seat’s elec-
trical connector (if equipped).
• Engage the seat's front rail into the
bracket at the rear of the fuel tank
and lower the rear rail in to the
rear brackets.
• Push down firmly on the rear of the
seat.
• Refit the passenger seat (see
Rider's Seat Height Adjustment
The rider's seat is adjustable for height
by approximately 25 mm.
2
4
5
3
1
1.
Rider's seat
2.
Front seat height adjuster
3.
Passenger seat height adjuster
4.
Low seat height position (rear shown)
5.
High seat height position (rear shown)
To adjust the rider's seat:
• Remove the rider's seat (see
104).
• Reposition both seat height adjust-
ers to the higher or lower position
as required.
• Make sure that both adjuster rails
are fully engaged in their brackets
on the seat.
• Refit the rider's seat (see page
Warning
Always adjust both seat height
adjusters. Adjusting only one height
adjuster may prevent correct fitment
of the seat.
Riding the motorcycle with an
incorrectly fitted seat may cause loss
of motorcycle control and an accident.
Warning
After adjusting the seat, operate the
motorcycle in an area free from traffic
to gain familiarity with the new seat
position.
Riding the motorcycle with the seat in
an unfamiliar position may cause loss
of motorcycle control and an accident.
Heated Seats (if fitted)
The heated seats switch (if fitted) is
located on the left hand side hand grip.
The heated seat switch operates both
the rider and passenger heated seats.
1
1.
Heated seat switch
