Triumph Speed Triple, Руководство пользователя

Страница: 94 / 136

94
Maintenance and Adjustment
Brake Pad Wear Compensation
Disc and brake pad wear is automatically
compensated for and has no effect on the
brake lever or pedal action. There are no
parts that require adjustment on the front
and rear brakes.
Disc Brake Fluid
Inspect the level of brake fluid in both
reservoirs and change the brake fluid in
accordance with scheduled maintenance
requirements. Use only DOT 4 fluid as
recommended in the Specification section.
The brake fluid must also be changed if it
becomes, or is suspected of having become
contaminated with moisture or any other
contaminants.
Warning
Brake pads must always be replaced as a
wheel set. At the front, where two calipers
are fitted on the same wheel, replace all
the brake pads in both calipers.
Replacing individual pads will reduce
braking efficiency and may cause an
accident.
After replacement brake pads have been
fitted, ride with extreme caution until the
new pads have 'broken in'.
Warning
If the brake lever or pedal feels soft when it
is applied, or if the lever/pedal travel
becomes excessive, there may be air in the
brake pipes and hoses or the brakes may
be defective.
It is dangerous to operate the motorcycle
under such conditions and your authorised
Triumph dealer must rectify the fault
before riding.
Riding with defective brakes may lead to
loss of motorcycle control and an accident.
Warning
Brake fluid is hygroscopic which means it
will absorb moisture from the air.
Any absorbed moisture will greatly reduce
the boiling point of the brake fluid causing
a reduction in braking efficiency.
Because of this, always replace brake fluid
in accordance with scheduled maintenance
requirements.
Always use new brake fluid from a sealed
container and never use fluid from an
unsealed container or from one which has
been previously opened.
Do not mix different brands or grades of
brake fluid.
Check for fluid leakage around brake
fittings, seals and joints and also check the
brake hoses for splits, deterioration and
damage.
Always rectify any faults before riding.
Failure to observe and act upon any of
these items may cause a dangerous riding
condition leading to loss of control and an
accident.