Assembly Instructions
NOTE: We recommend that two adults work together to assemble this game.
Find a clean, level place to begin the assembly of your Table Tennis Table. The table will be
assembled upside down and then turned over on its legs once the assembly is completed.
Remove all the parts from the box and verify that you have all of the parts as shown on the
parts list above. Carefully cut or tear the four corners of the box so that the bottom of the box
can be used as your work surface.
Step 1
Place Table Surface-A (#1)
and Table Surface-B (#2)
with the painted surface
facing down on a flat
surface.
Connect Table Surfaces
together using three
Brackets
(#9) using twelve Screws
(#A7). See FIG. 1 and 1A.
Attach the Safety Strap -
Long (#13) and Safety
Strap - Short (#14) to the
surface using three
Screws
(#A1). See FIG. 1.
Assembly Tips
:
Attention:
If you are using an electric screwdriver in the assembly, please set at low torque
and do not over tighten the hardware. When assembling individual parts, loosely tighten
screws until all screws are inserted, then tighten completely.
Note:
Center gap
tolerance
approximately 10~13mm.
Note:
Align the
inside seams of
each sections so
that pre-drilled
holes line up
across from
each other.
