Triumph Adler DC 2430, Инструкция по эксплуатации

Страница: 249 / 420

Default Setting (System Menu)
8-19
8
NOTE:
Refer to the
Character Entry Method on page Appendix-10
for details on entering characters.
4
Press [OK].
5
Press [Date and Time] to add the date/time to the job, or press [Job No.] to add the job number to the job.
The added information will be displayed in
Additional Info
.
6
Press [OK].
E-mail Subject/Body
Set the subject and body automatically entered (default subject and body) when sending the scanned originals
by E-mail.
NOTE:
Refer to
Send as E-mail on page 3-22
.
Use the procedure below to set the default e-mail subject and message body.
1
Press the
System Menu
key.
2
Press [Common Settings], [ ], [Next] of
Function Defaults
, [ ], and then [Change] of
E-mail Subject/Body
.
3
Press [Subject] to enter an E-mail subject not more than 60 characters.
NOTE:
Refer to the
Character Entry Method on page Appendix-10
for details on entering characters.
4
Press [OK].
5
Press [Body] to enter an E-mail Body not more than 500 characters.
6
Press [OK].
7
Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
NOTE:
Refer to
page 4-17
and
page 5-23 for Border Erase
.
Use the procedure below to set the default border erase width.
1
Press the
System Menu
key.
2
Press [Common Settings], [ ], [Next] of
Function Defaults
, [ ] and then [Change] of
Border Erase Default
.
3
Press [+] or [–] for the
Border
and
Gutter
width to erase.
Input units Range
Inch 0 to 2" (in 0.01" increments)
Metric 0 mm to 50 mm (in 1 mm increments)