a sound board that supports Sony/Philips digital interface (SPDIF) or Digital-In.
.
Analog audio output connector
: Outputs analog stereo signal. Use to connect to
sound board or audio amplifier. Use standard MPC-3 type, 4-pin connector.
.
DMA jumper
: Use the DMA jumper to convert between Ultra DMA Mode 0-2
(no jumper, default) and Multiword DMA Mode 0-2 (with jumper installed). In
general, leave this jumper at its factory setting, which is Ultra DMA (that is, no
jumper installed).
.
Mode jumper
: Use the mode jumper to select operation as an IDE master or
slave, or for cable select. In general, leave this jumper at its factory setting, which
is master.
.
IDE cable connector
: Connects to IDE (ATAPI) interface using 40-pin IDE flat
ribbon cable.
Precautions
Like the rest of your computer system, your DVD PRO I require reasonable care in
its installation and use.
.
Keep the area around your drive clean from dust, smoke, and other contaminants.
.
Do not allow moisture or liquids, including water or cleaning fluids, to touch the
drive. Thinner, benzene, or alcohol-based solvents can mar your drive’s surface.
.
Do not drop or jolt the drive.
.
Do not attempt to open the drive and service it yourself. Removing the cover may
expose you to harmful electrical voltages or the laser beam. For your safety,
entrust service to Tritton-authorized service personnel only.
.
Keep your Media free of dirt or other contaminants, by storing them in jewel cases.
Use only industry -standard discs. Do not insert dirty, warped, poorly balanced, or
cracked discs into the drive.
.
Do not clean discs using a circular motion. Instead, use a radial motion: start at
the center of the disc and proceed to the outer edge.
CAUTION
: Install your
DVD PRO I
horizontally. Tritton does not guarantee the drives
performance in a vertical position.
2. Installing Your DVD PRO I
This chapter explains how to
physically install your DVD PRO I in
your computer. The steps you'll need
to do are as follows:
1. Turn OFF your computer system.
2. Set the jumper for your new
DVD PRO I drive, if necessary.
3. Mount the DVD PRO I drive into
an available drive bay inside the
computer system.
4. Make all necessary cabling
connections: IDE cable, power
cable and audio cable.
5. Turn your computer system ON.
The following pages give more
details for this procedure
.
