Triton WRA 001, Руководство пользователя, Страница: 4 / 6

6
Thank you for purchasing this Triton tool. This manual contains information necessary for safe and effective operation of this product.
This product has unique features and, even if you are familiar with similar products, it is necessary to read this manual carefully to ensure
you fully understand the instructions. Ensure all users of the tool read and fully understand this manual.
Product Familiarisation
1. Uprights x 2
2. Screws x 12
3. Racks x 12
4. Spacers x 6
Assembly
1. The bottom of the Upright (1) has a small screw hole 13mm from the end.
Tighten a Screw (2) into this hole, then slide a Rack (3) down the Upright
until it locates onto the Screw. The notched side of the Rack (circled in Fig
I) must face down
2. Tighten a Screw into the next hole up, then slide another Rack into
position (Fig II). Continue this until all Racks are fitted. For alternative Rack
positions, drill additional 2.5mm holes. Repeat steps 1 and 2 (Fig I & II) for
the remaining Upright and Racks
3. Find a solid mounting location and ensure you are fixing to structural
supports when mounting. Space the Uprights around 1200mm to
1800mm (4’ to 6’) apart. For storage of very long materials use additional
WoodRacks
4. Fit the Spacers (4) over the mounting holes (Fig III) and fasten to the wall
using the recommended fasteners (not supplied) as outlined below:
Masonry (Fig IV)
Mounting to masonry: Use 6mm masonry anchors suitable for fixing 30 -
40mm thickness.
Storing small items: Construct a simple shelf for any of the levels as shown.
Timber (Fig V)
Mounting to timber: Use 5.5mm hex head wood screws, at least 65mm. Where
required, install vertical supports.
Outside use: For weather protection, staple horizontal battens to a plastic sheet
then fix the top batten above the racks.
Steel shed (Fig VI)
Mounting to a steel shed: Ensure racks are mounted to structural framework.
If steel, use minimum 6mm bolts. If wood, refer to Fig V (‘Mounting to timber’).
Install floor to roof verticals if required and secure to the steel sheet with
fasteners every 300mm.
555958_Z1MANPRO1_AUS.indd 2 18/07/2016 10:06