Triton TSPST450, Руководство пользователя

Страница: 10 / 12

10
Troubleshooting
Problem Possible cause Solution
No function when ON/OFF Switch is operated
No power Check power supply
Defective ON/OFF Switch
Have the ON/OFF Switch replaced at an authorised Triton
service centre
Sanding Sleeve (25) does not rotate with Sleeve Drum (31) Spindle Nut (27) not tight enough
Tighten Spindle Nut in small increments until the Sleeve
Drum secures the Sanding Sleeve
Sanding Belt does not remain at same height in use Tracking adjustment incorrect See ‘Tracking adjustment’
Large amounts of dust are being produced
Dust extractor passage is blocked
Turn off the machine at the mains. Remove the spindle
sander components or belt sander unit and remove the
blockage from the dust extractor passage
Incorrect Throat Plate used Change to the correct-sized Throat Plate
Sanding drum not operating at full speed
or motor sounds different to normal
Motor over-heating Switch OFF and allow to cool for a ½ hour
Motor faulty Contact an authorised Triton service centre
Brushes need replacing See ‘Brush replacement’
Motor belt worn or stretched Contact an authorised Triton service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children. If the tool
is permanently set up in a workshop or garage ensure access is restricted to prevent
children operating the tool.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
189888_Manual.indd 10 11/12/2018 13:35