Triton TGA250, Инструкция по эксплуатации и безопасности

Страница: 6 / 12

6
EN
Note:
The Table Spacer (6) is required when template routing on a router table.
1. Remove the insert ring from your router table
2. Remove the M4 Screws (4) and Alignment Bush (3) from the Guide Plate (1 or 2), and sit
the Table Spacer (6), recessed side up, into the centre of the Guide Plate
3. Align the screw holes, then fit the screws and the required Guide Bush (5, A – H)
Removing the guide plate
• Even when not using the template guides, the Guide Plate (1 or 2) can remain fitted to the
router for the majority of cuts, whether using the router hand-held or table-mounted
• However, if using cutters with a diameter greater than 50mm (2"), the Guide Plate (1 or 2)
will need to be removed
• To remove the guide plate, follow the fitting instructions above in reverse
Maintenance
WARNING: Always disconnect tools from the power supply before carrying out any
maintenance/cleaning.
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
• Regularly check that the M4 Screws (4) are tightened firmly
• When not using a guide bush, consider removing the M4 Screws and Alignment Bush (3)
for safe storage
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly,
and shorten the device’s service life. Clean the body of your machine with a soft brush, or
dry cloth. If available, use clean, dry, compressed air to blow through the ventilation holes
(where applicable)
164990_Manual.indd 6 20/12/2018 11:51