Triton T22i, Инструкция по установке и эксплуатации, Страница: 8 / 16

Shower pump
INSTallaTION
Before installing the pump, make sure the site
conditions have been complied with fully.
Also note the following:
•
Pipework to precede wiring.
• Position the pump in a dry area, preferably
in a linen/airing cupboard, where it must be
well ventilated and not covered with towels
and sheets, etc.
• DO NOT use with a combination cylinder
system unless the cold water cistern has
capacity of 225 litres (50 galls) or more.
• To assist in clearing air bubbles from the
system avoid using sharp bends where
possible. Flexible/swept fittings or formed
pipework is recommended.
• Make sure that all water supplies are
isolated before connection. Gate valves or
full way lever valves must be fitted in the
connections to the pump. It is also advisable
to fit a drain off point on the lowest part of
the system.
• NEVER use any form of soldered fittings on
the shower pump as this will damage the
unit and invalidate the guarantee.
• NEVER use solder within 300mm of the
pump or expose parts to a hot torch.
• Make sure the mains electricity supply is
SWITCHED OFF before making the electrical
connections.
• DO NOT OPERATE THE PUMP DRY. This may
cause damage to the seals and will invalidate
the guarantee.
note: The pump motor has automatically
resetting thermal overload protection.
warnInG!
Installation of the pump will break
the earth continuity of the pipework
installation. It is important that the
earth be restored by cross bonding the
pipework, to conform with current IEE
regulations.
SITING Of THE PUmP
The pump MUST ALWAYS be positioned
BELOW the cold water cistern and be situated
as close as possible to the hot water cylinder. It
is recommended that the cold water supply is
taken from the opposite side of the cistern to the
float operated valve to prevent air entrapment in
the supply.
The pump should be located as close as possible
to the water supplies to obtain maximum
performance and positioned below the level of
the mixing valve if possible.
Position the pump in a suitable area and make
sure it is accessible for any maintenance etc. that
may be necessary.
ImporTanT: make sure there is sufficient
ventilation around the pump to cool the
motor.
warnInG!
ThE unIT musT noT BE posITIonED
whErE IT wILL BE suBJECT To
FrEEZInG ConDITIons.