Triton LocBoard LBC-4, Инструкция по сборке

Страница: 2 / 4

2
5. (Refer to Figure 1-1 and 2-4) Attaching rail end bracket to top rail and Corner angle brackets; Position end
bracket with taper facing up and preinstalled fasteners facing inward. (Flat surface of end bracket with the flat
inside surface of angle brackets.), Slide end bracket in and behind both right and left corner angle brackets. Align
the four bolt holes of each corner angle bracket with the preinstalled fasteners on rail end bracket. Install (4) ¼”
hex head bolts with lock washers and tighten partially. (Repeat step #5 for opposite end.)
6.
(Figure 2-1 and 2-3) Tighten all (8) ¼” tapered flat head screws on the front side used to attach corner angle
brackets to top rail and bottom tray. (These will be the only screws tightened at this time. All end bolts must
remain loose.)
7.
(Figure 2-1) Pull handle installation: Locate the right corner angle bracket with the 4 extra fastener holes at the
top. Install pull handle using ¼” tapered head bolts. (Note: Handle will be positioned at end of tool cart that
swivel casters will be installed on.)
8.
(Figure 1-2 AND 2-1) Installation of Casters: (Note: Bottom tray has two different bolt patterns for casters.)
Swivel casters will be installed on the end of tool cart with handle and bolt patterns that are slightly inset and
parallels the END section of the cart. With end of cart raised or laying on its side insert ¼” hex head bolts with cut
lock washer through bottom side of caster mount plate and through holes in bottom tray, install flat washer and
secure in place using ¼” hex head nut. Tighten securely after all 4 bolts have been installed. (Repeat for each
caster.)
9. (Figure 2-1, 2-4, 2- and 2-7) Installation of LocBoard: Before attaching LocBoards tighten Phillips Flat head
w/ Under-Hut Head in all 4 corner angle brackets on both side of the cart .Each LocBoard has 3 internal
ribbed support brackets welded on the backside with pre-punched mounting holes. Mounting holes will be
accessed from the front side through the square holes in each board. You will be using only the Top and Bottom
ribbed support brackets for this installation. (Using figure 2-4, 2-6 & 2-7) Identify board top from its bottom.
From the Front of the tool cart with smooth surface of LocBoard facing you, align top two mount holes (3 Rows
Square hole down and 2 Rows in from each edge) with the two preinstalled fasteners on the front edge of top rail.
Using an Allen wrench, insert 12-24 X ¾” socket head cap screw.
(Make sure fasteners go in straight and turn
without restriction. Avoid stripping while installing. You may have to move board slightly to allow screws
to turn freely.)
Tighten until screw head is just below surface of the board. Install (2) remaining bottom
mounting screws in same manner. (Keep all screws loose until finished installing all (4) LocBoards.)
Special Note:
Should any of the preinstalled fasteners loosen or fall out during assembly, replace using either a ¼”- 20
or 12-24 threaded nut with lock washer in its place.
10. Once finished installing all (4) LocBoards, finish assembly by securely tightening all fasteners throughout
assembled cart.
Secure storage for all items can be achieved using LocHook™ locking steel pegboard hooks.
For all assembly questions or missing parts request please contact
Triton Products directly @ 440-248-5480
www.tritonproducts.com