Triton Ivory 2, Инструкция по установке и эксплуатации

Страница: 10 / 29

If a bottom entry has been chosen, fit the
supplied pipe trim in the top of the backplate
(fig.7) .
If a top entry has been chosen, fit the supplied
pipe trim in the bottom of the trimplate
(fig.8) .
If a side entry is required, the trimplate side will
have to be cut. With the elbow compression
fitted on the outlet, temporarily place the
trimplate into position, then mark the pipe entry
on the side of the trimplate. Carefully remove
the appropriate area by using a junior hacksaw.
If installing a feed pipe from the back or
bottom, the centre of the inlet valve to the wall
surface is 20mm
(fig.9) .
Note: If entry is from the back, the nut of the
compression fitting will be partially behind the
surface of the wall. This area MUST be left clear
when plastering over the pipework in order to
make the nut accessible for future adjustments.
Installation
FITTING THE SHOWER TO THE WALL
Note: The control knobs are an integral part of
the cover – DO NOT attempt to remove them.
IMPORTANT: The unit must be mounted on a
flat surface which covers the full width and
length of the backplate. It is important that
the wall surface is flat otherwise difficulty
may be encountered when fitting the cover
and subsequent operation of the unit may be
impaired.
Lift the cover from the backplate. To facilitate the
pipe and cable connections, remove the trimplate
by removing the two fixings screws
(fig.6) .
Entry positions for the mains water and electric
cable are from the top, bottom, either side or
from the back.
Note: Deviations from the designated entry
points will invalidate product approvals.
20
mm
Fig.8
Fig.9
Fig.7
Fig.6
8