TR-MQ 1500
English
Pag. 3
User Manual
1.- Specifications
Input voltage:
AC 110V 50/60Hz AC220V 50/60Hz
Watts:
1500W
Output:
2 0.000 cu.ft. /min
Tank:
6 l.
Warm-up:
10 min.
Dimensions (mm):
620 x 300 x 210.
Weight:
15 kgs.
Fuse specificatio:
F15A 250V (AC 110V)
F10A 250V (AC220V)
2.- Display Panel and LED Indicator Status
STANDBY
:Green Light on, Working;Red Light on, standby, LCD off
READY
: Off, lower than certain temperature, Green light on, suitable
temperature, fogger machine workable
Flickering green light shows over high temperature, and fogger machine
shutter heating system for its self-protection.
TIMER ON
: When“TIME ON” not start, indicator off, Start “TIME ON”,
Yellow light on
SMOKE ON
: Off, spray no smoke; Green light on, ready to spray smoke.
3.- Operation Instructions:
Check the PSU specifications of fogger machine, connect it to power correctly; after system checked, Machine
specifications, version date will be showed, then last working mode and parameter after 1 sec.
MODE Button: presses “MODE”, change one kind of mode, the recycling mode is as follows:
Mode Introduction:
1.- DMX Mode:
Display
DMX Add setting: The address from “001” to “512”varies by pressing “UP” and “DOWM”. When the value of address
is the same as the one of the controller, fixture will receive two continuous channel data: the chief channel controls the
smoke volume while the subordination, the wind volume.
2.- MANUAL Mode
: Display
Channel switch: switch smoke channel to wind channel by pressing “SHIFT” visa vice (w/”>”sign). Smoke and wind
volume setting: once smoke or wind switch set, the volume of smoke or wind varies by pressing “UP” or “DOWN”.
Smoke and wind output: After temperature gets to a point, start input or close input by pressing “OK”.
TR-MQ 1500 REV
2006 05 05
DMX
MANUAL
TIMERE
REMOTE
SWICTH OFF
Op mode DMX ch:xxx
FOG:xxx% FAN:xxx%
Op mode MANUAL
FOG:xxx% FAN:xxx%
