Tritech Merlin, Руководство по эксплуатации продукта

Страница: 15 / 32

Maintenance Merlin
0711-SOM-00001, Issue: 03 15 © Tritech International Ltd.
Check hoses are secure.
Check mountings are secure.
Check clean water suction strainer is in place and clear.
Check the mini compensator for the seal housing is extended. If not apply one or two strokes
with a grease gun until the compensator relieves.
Storage
Note
If the vehicle will be inactive for more than 48 hours run a a fresh water hose into
the clean water suction strainer for a few minutes and then spin the hydraulic
motor for about 15 seconds (taking care not to over-speed).
If the pump is removed from the vehicle, then the hydraulic ports should be blanked off with
metal caps and the unit washed out with fresh water.
Leave the actuator valves in their retracted position.
Visually inspect the leading edges of the power pump impeller for damage and erosion.
Up to four blades may have leading edge damage of 5mm width and 4mm depth before
replacement becomes essential.
If the majority of leading edges are eroded more than 3.5mm back from the bore of the inlet
nozzle then consideration should be give to replacing the impeller.
5.3. Fitting Spacer to Retro Valve Actuator
Over the lifetime of the Merlin Pump wear to the Retro Valve Core may cause the actuator
that drives it to go into geometric lock.
This procedure explains the fitting of Merlin Actuator Spacer (see Appendix C,
Merlin Actuator
Spacer
) to allow continued operation of the Merlin Pump.