5
3. Installation
3.4 Installation Across Aisle
Note:
Follow the instructions in this section only if the SRCABLELADDER18 accessory will be installed across an aisle. If the SRCABLELADDER18 accessory
will be installed within a row of enclosures, follow the instructions in
Section 3.5 Installation Within Row
instead.
1
Insert four assembly brackets
A
into the ends of the ladder.
The hooked ends of the brackets should be exposed. When
the ladder is oriented so that the ladder’s rungs are above the
ladder’s side rails, the hooked ends of the brackets should point
down, as shown in the drawing.
2
Align the pin holes in the ladder sections with the pin holes in
the assembly brackets and insert clevis pins
B
into the pin
holes (4 total). This step may be omitted to provide additional
installation flexibility, but installing the pins will make the
SRCABLELADDER18 accessory more stable.
Warning: If you choose not to install the clevis pins, make
sure at least 25% of the length of each assembly bracket is
inside the ladder.
3
After inserting the clevis pins, insert a cotter pin
C
through the
hole at the end of each clevis pin. (The straight section of the
cotter pin goes through the hole.)
4
Using an assistant, lift the SRCABLELADDER18 accessory (rungs
upward) and insert the exposed hook ends of the assembly
brackets
D
into the corresponding slots
E
in the SRCABLETRAY
accessories installed at the top of each enclosure. The hooks
should fit the slots securely by sliding down to engage the edge
of the slot.
Note:
There are two levels of slots. Use the slots that match your
application best.
2
3
1
4
A
A
D
E
B
B
C
