Tripp Lite SmartOnline SU1000RTXLCD2U, Руководство пользователя

Страница: 24 / 96

 
 
 
 
1: OVERLOAD
SCROLL SELECT
ENABLE*
SCROLL SELECT

 
FW VER:FW#####
SCROLL SELECT
 
 
24
Operation
14 The AUDIBLE ALARM selection screen will appear.
The AUDIBLE ALARM screen gives the user the ability to permanently enable or disable the
UPS’s audible alarm in case of an alarm event. The factory configuration of ENABLE is ideal
for most applications. Certain applications may require the alarm to be disabled, in which
case the option of DISABLE can be selected.
15
The ALARM HISTORY selection screen will appear.
ALARM HISTORY displays up to 5 alarm events. Possible alarms include CHARGER FAULT,
FAN FAULT, OVER TEMP, +/-DC BUS HIGH/LOW, BUS OVP, INVERTER FAULT, BATTERY FAULT,
DC-DC FAULT, OVERLOAD, O/P SHORT, NO BATTERY, SITE WIRE FAULT, BYPASS VOLT BAD,
BYPASS FREQ BAD, INPUT OVERCURRENT, and BATTERY LOW.
16
The INFORMATION screen will appear.
INFORMATION refers to a series of 3 information screens that are viewable via the LCD
interface: Firmware version, UPS serial number and SNMP IP address. These values are for
viewing only and cannot be modified via the LCD interface
17 The ORIGINAL UPS SET-UP EXIT/ENTER screen will appear.
To Change This
Setting:
Press “SELECT” (^)
Press SELECT (^) to SET this value.
Press SCROLL (
v
) to advance to the next option.
Available values are: ENABLE, DISABLE
Scroll through available values and press
SELECT (^) to SET.
Factory Default: ENABLE
To Advance to
the Next Screen:
Press SCROLL (
v
)
To Change This
Setting:
Press “SELECT” (^)
Press “SELECT” (^) to SET this value.
Press “SCROLL” (
v
) to advance to the next option.
Available values are: ALARM HISTORY 1-5 &
ERASE
Scroll through available values and press
SELECT (^) to SET
To Advance to
the Next Screen:
Press SCROLL (
v
)
To Change This
Setting:
Press “SELECT” (^)
Press “SELECT” (^) to EXIT this section.
Press “SCROLL” (
v
) to advance to the next
information screen.
Available Information: FIRMWARE VERSION,
UPS SERIAL #, SNMP IP ADDRESS
Scroll through available values and press
SELECT (^) to EXIT.
To Advance to
the Next Screen:
Press SCROLL (
v
)
Press EXIT (
v
) to exit the UPS SET-UP section.
Press “ENTER” (
^
) to re-enter UPS SET-UP screens.