4
A
A
B
C
C
B
1
2
3
4
D
D
Mounting (Rack)
Mount your equipment in either a 2-post or 4-post rack or rack enclosure. The user must
determine the fitness of hardware and procedures before mounting. If hardware and procedures
are not suitable for your application, contact the manufacturer of your rack or rack enclosure. The
procedures described in this manual are for common rack and rack enclosure types and may not be
appropriate for all applications.
Note:
The illustrations may differ from your model.
4-Post Mounting
1
The included plastic pegs
A
will temporarily
support the empty rack-mount shelves
B
while you install the permanent mounting
hardware. Insert a peg near the center of
the front and rear bracket of each shelf as
shown. (Each front bracket has 6 holes and
each rear bracket has 3 holes.) The pegs
will snap into place.
After installing the pegs, expand each shelf
to match the depth of your rack rails. The
pegs will fit through the square holes in
the rack rails to support the shelves. Refer
to the rack unit labels to confirm that the
shelves are level in all directions.
Note:
The support ledge of each shelf must face
inward.
2
Secure the shelves
B
to the mounting rails
permanently using the included screws and
cup washers
C
as shown. Place the cup
washer between the screw and the rack so
that the screw enters the wider opening of
the cup washer first.
Place 4 screws total at the front and 4
screws total at the back.
Tighten all screws before proceeding.
WARNING: Do not attempt to install
your equipment until you have inserted
and tightened the required screws. The
plastic pegs will not support the weight
of your equipment.
3
Attach your equipment’s mounting brackets
to the forward mounting holes of the cabinet
using the hardware included with your
equipment. The mounting bracket “ears”
should face forward. (Some equipment
may have pre-installed or integral mounting
brackets.)
4
With the aid of an assistant (if necessary),
lift your equipment and slide it into the
shelves. Attach the equipment mounting
brackets to the forward mounting rails
with user-supplied screws and washers
D
.
Tighten all screws securely.
21-10-012 - 933148-Book.indb 4
21-10-012 - 933148-Book.indb 4
10/14/2021 1:10:22 PM
10/14/2021 1:10:22 PM
